What else should I be doing while all these parts are off...

Mad Kiwi · Post by **Mad Kiwi** » Wed Mar 14, 2012 8:07 am

Hi Guys

I am in the middle of installing a 949 Racing "M-Tuned" coolant reroute.

Currently have CAS out, rear water housing off, Valve Cover off (for painting) etc.

I intend on replacing the CAS seal and heater hoses, anyone else think of other things to do while the rear access is improved?

Mark

Kieran · Post by **Kieran** » Wed Mar 14, 2012 10:18 am

remove the bolt under the coil pack its a bitch to get with the motor in and its useless

Mad Kiwi · Post by **Mad Kiwi** » Wed Mar 14, 2012 10:53 am

Thanks Kieran, that was one I had been considering.

Kieran · Post by **Kieran** » Wed Mar 14, 2012 11:18 am

yeah i spent too long trying to get it out when i took the valve cover off

sprsta · Post by **sprsta** » Wed Mar 14, 2012 12:39 pm

I did the BEGI reroute
for the hose i used the same one as in this article
http://revlimiter.net/blog/2011/05/coolant-re-route-1/
http://revlimiter.net/blog/2011/06/coolant-re-route-2/

i searched high and low and eventually born_desturbed found me one at Bunce motors in wairau

it worked really well

good luck

What else should I be doing while all these parts are off...

What else should I be doing while all these parts are off...

Who is online