Clutch recommendations
Moderators: Growler, jif, SLYDIT, Born_disturbed
-
- I have stars, you haven't. Deal with it
- Posts: 1115
- Joined: Fri Jun 08, 2012 12:21 am
- Location: Auckland
Looking at a workshop manual it doesnt seem like too much of a big job, will just take a while.
Have been told to get the flywheel ground for the new clutch so will have to take it into work with me as i work across the road from franklin cams.
Looks like a basic spanner set would almost be enough to do the change
Have been told to get the flywheel ground for the new clutch so will have to take it into work with me as i work across the road from franklin cams.
Looks like a basic spanner set would almost be enough to do the change
-
- I have stars, you haven't. Deal with it
- Posts: 1293
- Joined: Wed Dec 24, 2008 11:35 am
- Location: 36.8167° S, 174.4167° E
siren676....Looks like a basic spanner set would almost be enough to do the change
And a decent socket set with universal socket plus extra extension bars to reach up to the top Bell-housing bolts!
Probably a power bar too if it hasn't been off for awhile.
And dont forget to do the rear crank oil seal!
And a torque wrench for re-installation of everything.
And a decent socket set with universal socket plus extra extension bars to reach up to the top Bell-housing bolts!
Probably a power bar too if it hasn't been off for awhile.
And dont forget to do the rear crank oil seal!
And a torque wrench for re-installation of everything.
1989 NA 1650
1998 NB 1800
2005 NC 2000
1990 Landcruiser
Surfboard
Push-bike
Hiking shoes
1998 NB 1800
2005 NC 2000
1990 Landcruiser
Surfboard
Push-bike
Hiking shoes
-
- I have stars, you haven't. Deal with it
- Posts: 1293
- Joined: Wed Dec 24, 2008 11:35 am
- Location: 36.8167° S, 174.4167° E
Can do but its no biggie if you dont have the alignment tool..i use a socket or something similar...sometimes you fluke just by eyeing it!
If you want to keep your oil in the gearbox then there is a special plug that goes in the end of the gearbox or use an old drive shaft front yoke to plug it otherwise oil pours out everywhere and all over your Sunday best!
If you want to keep your oil in the gearbox then there is a special plug that goes in the end of the gearbox or use an old drive shaft front yoke to plug it otherwise oil pours out everywhere and all over your Sunday best!
1989 NA 1650
1998 NB 1800
2005 NC 2000
1990 Landcruiser
Surfboard
Push-bike
Hiking shoes
1998 NB 1800
2005 NC 2000
1990 Landcruiser
Surfboard
Push-bike
Hiking shoes
Who is online
Users browsing this forum: No registered users and 4 guests