Hi Gary.Did you just replace them with factory bushes, or did you source aftermarket ones.
M@
Suspension bushes
-
- Need, more, 5-ing, time....
- Posts: 100
- Joined: Sun Jun 04, 2006 3:24 pm
- Location: Wellington
Suspension bushes
Hi Matthew,
I used the factory ones. Cost for the rear set was about $450. As the suspension was in bits it wasn't too much of a job, except that I had the old bushes pressed out, the suspension parts stripped and powder coated, and then the new bushes pressed in. That all cost about $100. There is a set from Flyin Miata in the USA, Powerflex I think, and they seem to work out about the same or slightly less. They are a urethane set I think, and supposedly should last forever.
Gary
On Fri, 15 Nov 2002 10:18:25 +1300, Mathew wrote:
Hi Gary.Did you just replace them with factory bushes, or did you source aftermarket ones.
M@
I used the factory ones. Cost for the rear set was about $450. As the suspension was in bits it wasn't too much of a job, except that I had the old bushes pressed out, the suspension parts stripped and powder coated, and then the new bushes pressed in. That all cost about $100. There is a set from Flyin Miata in the USA, Powerflex I think, and they seem to work out about the same or slightly less. They are a urethane set I think, and supposedly should last forever.
Gary
On Fri, 15 Nov 2002 10:18:25 +1300, Mathew wrote:
Hi Gary.Did you just replace them with factory bushes, or did you source aftermarket ones.
M@
Who is online
Users browsing this forum: No registered users and 5 guests