NA6 Extractors?

REDBEN · Post by **REDBEN** » Fri Jan 04, 2013 1:46 pm

Does anyone know where I could purchase a good set of B6 extractors? Just as a replacement as my current one leaks like a sieve and has a lot of magic mud stuffed around it

authentic · Post by **authentic** » Fri Jan 04, 2013 2:02 pm

There are quite a few nice examples on Yahoo Japan, if you're willing to spend a bit more for good aftermarket brands. I just bought a set through Ewan at hayatonka.

Snapfrozen · Post by **Snapfrozen** » Fri Jan 04, 2013 2:36 pm

Also make a note that you will probably gain very little. Factory header is quite good.

REDBEN · Post by **REDBEN** » Fri Jan 04, 2013 3:03 pm

Snapfrozen wrote:Also make a note that you will probably gain very little. Factory header is quite good.

Not when their leaking at the collector

REDBEN · Post by **REDBEN** » Fri Jan 04, 2013 3:03 pm

authentic wrote:There are quite a few nice examples on Yahoo Japan, if you're willing to spend a bit more for good aftermarket brands. I just bought a set through Ewan at hayatonka.

Any photo's?

WideOpenThrottle · Post by **WideOpenThrottle** » Fri Jan 04, 2013 3:07 pm

I got some off my NA1600 but it does need the O2 bung welded back in.

authentic · Post by **authentic** » Fri Jan 04, 2013 3:11 pm

The auction closed about 12 hours ago

but they are 'Cusco Powerball' headers. A bit of sanding and polishing will have them looking nice again.

I was looking at these ones also http://page9.auctions.yahoo.co.jp/jp/auction/k160747941 , but the Cusco ones popped up and I decided to go for them.

REDBEN · Post by **REDBEN** » Fri Jan 04, 2013 5:23 pm

WideOpenThrottle wrote:I got some off my NA1600 but it does need the O2 bung welded back in.

Are they Factory ones? I can weld so not a big deal to me? What material?

WideOpenThrottle · Post by **WideOpenThrottle** » Fri Jan 04, 2013 7:46 pm

Factory original if thats what you are after & i may have a bung as well

NA6 Extractors?

NA6 Extractors?

Who is online