Sodding Nardi wooden gear knob

4A-GE · Post by **4A-GE** » Fri Oct 31, 2014 5:45 pm

Problem: I have a nice nardi knob except the wood bit spins freely on the aluminium bit that screws onto the gearstick. This is annoying because I hate stuff that moves when it shouldn't and it also makes an awful noise.

How the beep do I fix it? Does the aluminium insert come out of the wood bit or am I stuck with dumping glue into it until it stops moving?
Pun absolutely intended.

send help

SkilletKid · Post by **SkilletKid** » Sat Nov 01, 2014 12:32 am

Mine had a set screw that you can use to tighten the knob onto the actual shifter. I'll see if I can find it.

4A-GE · Post by **4A-GE** » Sat Nov 01, 2014 1:17 am

Mine has that. Aluminium bit tightens onto the stick just fine, but the wood bit twists and squeals.

SLYDIT · Post by **SLYDIT** » Sat Nov 01, 2014 6:48 pm

keep twisting and pull at the same time? then glue it back on with epoxy??

4A-GE · Post by **4A-GE** » Sat Nov 01, 2014 6:59 pm

Twisting and pulling? Oh my.

Nah yeah that's next on the list

SLYDIT · Post by **SLYDIT** » Sat Nov 01, 2014 7:42 pm

didnt ya mum tell you//if you twist and pull ya knob it will eventually fall off. LOL

4A-GE · Post by **4A-GE** » Sat Nov 01, 2014 7:44 pm

Aaaaaaand there's the dick joke.

Sodding Nardi wooden gear knob

Sodding Nardi wooden gear knob

Who is online